Description
The ‘PPprint Printing-Kit for Raise3D Pro3’ was specifically tailored to the Raise3D Pro3 Series and includes everything you need for successful and reliable extrusion-based 3D printing with the polypropylene filament ‘P-filament 721’. The included printing surface ‘P-surface 141’ guarantees optimized adhesion of the PP component during 3D printing and allows easy and non-destructive removal of the components after completion. The double-sided adhesive film ‘P-adhesive 220’ is used to fix the ‘P-surface 141’ in the 3D printer. The hand roller ‘P-roller 621’ makes it easier to apply the print run. In addition, ‘P-wipe 515’ and ‘P-cleaner 308’ can be used to advantage for cleaning and maintaining the ‘P-surface 141’ and thus have a positive effect on the service life of the ‘P-surface 141’.
For more information about the individual components of the ‘PPprint Printing-Kit for Bambu Lab H2D’, please refer to the descriptions of the individual products.
Products of the ‘PPprint Printing-Kit for Bambu Lab H2D’:
– P-surface 141 (350mm x 320mm)
– P-adhesive 220 (350 mm x 320 mm)
– P-cutter
Instructions for applying the ‘P-surface 141’
P-filament 721 printing profile for Raise3D Pro3 Series
Cleaning and maintenance of the ‘P-surface 141‘: Before first use, wash out the ‘P-wipe 515’ thoroughly with lukewarm water. Shake ‘P-cleaner 308’ thoroughly before use. To clean the ‘P-surface 141’, apply enough ‘P-cleaner 308’ so that the entire surface is evenly covered with a paper towel after spreading. After a short soaking time of approx. 1 minute, the ‘P-cleaner 308’ can be completely removed with the paper towel. Finally, the ‘P-surface 141’ should be wiped off with the moistened ‘P-wipe 515’. After use, wash out the ‘P-wipe 515’ in clear water, wring out carefully and then pull into shape. Do not dry the ‘P-wipe 515’ in the sun or on radiators.
Security alert:
May cause burns if swallowed and if it enters the airways. May cause skin irritation. May cause eye irritation. Keep out of the reach of children. Wear protective gloves/eye protection IF SWALLOWED: Call a POISON CENTER/doctor/first aid if you feel unwell. IF ON SKIN TOUCH: Wash with plenty of soap/water. IF IN EYES: Rinse cautiously with water for several minutes. Remove any contact lenses if possible. Continue rinsing. If eye irritation persists, seek medical advice/attention. Dispose of the contents/container in accordance with local regulations. Contains: Ethanol, alkyl glycosides (C8-C10), N,N-dimethyl-9-decenamide.
To the best of our knowledge, this product does not present any special hazard when handled in accordance with good occupational hygiene and safety practices for the cleaning and maintenance of ‘P-surface 141‘
Labeling according to Regulation (EC) No 1272/2008 [CLP] is not applicable.
Sicherheits-Datenblatt
EAN Nummer: 0049364177089
